The moment of inertia is a tensor because it behaves both as a scalar and a vector. This is because the moment of inertia at times depends on the... View Article
Oscillators act as a clock to the microcontroller. In a microcontroller, every instruction is executed in synchronization with the clock.... View Article
The measured voltage is smaller than the theoretical voltage because it is specified for ideal conditions for a new, unused cell. However, in... View Article
Parasitic oscillation is an undesirable electronic oscillation that normally occurs in an electronic or digital device. It is a result of the... View Article
The voltage decreases when concentration increases because increasing the concentration increases the resistance, decreasing the potential difference.... View Article
Yes, Gauss law is always true. The law states that the total flux linked with a closed surface is 1/ε0 times the charge enclosed by the closed surface.... View Article
A permeability coefficient is the quantitative measure of the rate at which a molecule can cross a membrane such as a lipid bilayer. It is... View Article
Iron is a moderately active element, and its oxides can be reduced using carbon and not by electrolysis. On the basis of energy considerations,... View Article
The energy in a battery is stored in the form of chemical potential energy. The stored chemical potential energy of a battery is converted into... View Article
The absorption of a wave is when a wave comes into contact with a medium and causes the medium's molecules to vibrate and move. This vibration... View Article
NPN transistor is used as an amplifier when it is forward biased. The electrons move from emitter to base under forward bias condition, and holes... View Article
When the distance between slits within the grating is increased, bands get closer together and eventually merge to form an image of the grating.... View Article
The enthalpy change is often associated with energy changes. The change in enthalpy is negative when the chemical reaction is exothermic in... View Article
Normally, we calculate the enthalpy change that occurs during a chemical reaction. An enthalpy change is the amount of heat absorbed or released... View Article
Yes, a transistor can amplify an AC signal. A transistor amplifies the small-current input signal into high-current output at the same voltage;... View Article
The potential difference is what causes the current to flow in a circuit. Multiply the amount of current by the circuit’s resistance to obtain... View Article
For Young’s double-slit experiment, to determine the slit width, we make use of the following equation: where is the wavelength of the light,... View Article
