Factors Affecting Alpha
Trending Questions
Q. The plot given below shows P - T curves (where P is pressure and T is the temperature) for two solvents X and Y and isomolal solutions of NaCl in these solvents. NaCl completely dissociates in both the solvents.
On addition of equal number of moles of a non-volatile solute S in equal amount (in kg) of these solvents, the elevation of boiling point of solvent X is three times than that of solvent Y. Solute S is known to undergo dimerization in these solvents. If the degree of dimerization is 0.7 in solvent Y, the degree of dimerization in solvent X is:
On addition of equal number of moles of a non-volatile solute S in equal amount (in kg) of these solvents, the elevation of boiling point of solvent X is three times than that of solvent Y. Solute S is known to undergo dimerization in these solvents. If the degree of dimerization is 0.7 in solvent Y, the degree of dimerization in solvent X is:
Q.
Which of the following is the strongest acid ?
H2SO3
H2SO4
HClO4
H3PO4
Q. Percentage ionization of weak acid can be calculated using the formula:
- 100√KaC
- 1001+10(pKa−pH)
- Both (a) and (b)
- none
Q. The gas phase reaction,
2A(g)→A2(g) at 400K has ΔG∘=+25.2 kJ mol–1
The equilibrium constant, KC for this reaction is ______ × 10−2 (Round off to the Nearest Integer).
[Use : R=8.3 J mol–1 K–1, ln 10 = 2.3
log10 2=0.30, 1 atm=1 bar]
[antilog (– 0.3) = 0.501]
2A(g)→A2(g) at 400K has ΔG∘=+25.2 kJ mol–1
The equilibrium constant, KC for this reaction is ______ × 10−2 (Round off to the Nearest Integer).
[Use : R=8.3 J mol–1 K–1, ln 10 = 2.3
log10 2=0.30, 1 atm=1 bar]
[antilog (– 0.3) = 0.501]
Q. The concentration of formate ion (HCOO−) present in 0.1 M formic acid (HCOOH) solution at equilibrium is :
(Ka=1.6×10−4)
(Ka=1.6×10−4)
- 4×10−3 M
- 3×10−6 M
- 1.5×10−3 M
- 5×10−6 M
Q. A weak acid HX has the dissociation constant 1×10−5 M. It forms a salt NaX on reaction with alkali. The percentage degree of hydrolysis of 0.1 M solution of NaX is:
- 0.0001 %
- 0.01 %
- 0.1%
- 0.15 %
Q. When 0.1 mol of ammonia (NH3) is dissolved in sufficient water to make 1 L of solution, the solution is found to have a hydroxide ion (OH−) concentration of 1.5×10−3 M . The value of Kb for NH3 is:
- 0.5×10−3 M
- 2.28×10−5 M
- 8.65×10−2 M
- 5.75×10−6 M
Q. For the reversible reaction, N2(g)+3 H2(g)⇌2 NH3(g) at 500oC, the value of Kp is 1.44×10−5, when partial pressure is measured in atmosphere. The corresponding value of Kc, with concentration in mol L−1, is
- 1.44×10−5(0.082×500)−2
- 1.44×10−5(8.314×773)−2
- 1.44×10−5(0.082×773)2
- 1.44×10−5(0.082×773)−2
Q. Calculate the pH of solution when 100 mL, 0.1 M CH3COOH and 100 mL, 0.1 M HCOOH are mix together (Given : Ka(CH3COOH)=2×10−5, Ka(HCOOH)=6×10−5) (Given: log2=0.30)
Q. A buffer solution can be prepared from a mixture of:
(i) Sodium acetate and acetic acid in water
(ii) Sodium acetate and hydrochloric acid in water
(iii) Ammonia and ammonium chloride in water
(iv) Ammonia and sodium hydroxide in water
(i) Sodium acetate and acetic acid in water
(ii) Sodium acetate and hydrochloric acid in water
(iii) Ammonia and ammonium chloride in water
(iv) Ammonia and sodium hydroxide in water
- (i), (ii), (iii)
- (ii), (iii)
- (iii), (iv)
- (i), (iii)
Q.
On addition of ammonium chloride to a solution of ammonium hydroxide
Dissociation of NH4OH increases
Concentration of OH- increases
Concentration of OH- decreases
Concentration of NH4+ and OH- increases
Q. The first and second dissociation constant of an acid H2A are 1.0×10−5 and 5.0×10−10 respectively. The overall dissociation constant of the acid will be:
- 5.0×10−5
- 5.0×1015
- 0.2×105
- 5.0×10−15
Q. The pKa values of four carboxylic acids are given below. Identify the weakest carboxylic acid.
- 4.89
- 1.28
- 4.76
- 2.56
Q. An aqueous solution of a salt MX2 at certain temperature has a van't Hoff factor of 2. The degree of dissociation for this solution of the salt is:
(JEE Main - 2016)
(JEE Main - 2016)
- 0.67
- 0.33
- 0.50
- 0.80
Q. what is the concentration of chloride ions in the mixture of 500ml , 1M NaCl solution and 500 ml , 1M CaCl2 solution
Q. When 0.1 mole solid NaOH is added in 1 lt of 0.1 M NH3(aq) then which statement is wrong? (Kb=2×10−5, log2=0.3)
- Degree of dissociation of NH3 approaches to zero.
- On addition of OH−Kb of NH3 does not changes.
- Change in pH by adding NaOH would be 1.85
- In solution, [Na+]=0.1M, [NH3]=0.1M, [OH−]=0.2M.
Q. For A(g)⇌2B(g), equilibrium constant at total equilibrium pressure p1 is KP1and for C(g) ⇌D(g)+E(g),
equilibrium constant at total equilibrium pressure P2 is Kp2. If degree of dissociation of A and C are same, then the ratio KP1/KP2, if 2P1=P2, is:
equilibrium constant at total equilibrium pressure P2 is Kp2. If degree of dissociation of A and C are same, then the ratio KP1/KP2, if 2P1=P2, is:
- 2
- 18
- 12
- 8
Q. The sodium salt of a certain weak monobasic organic acid is hydrolysed to an extent of 3% in its 0.1 M solution at 25∘C given that the ionic product of water is 10−14 at this temperature, what is the dissociation constant of the acid?
- 1.1×10−10
- 1.1×10−9
- 3.33×10−9
- 3.33×10−10
Q. The pH of 0.05 M aqueous solution of diethyl amine is 12.0. Calculate Kb.
- 2.5×10−4
- 5×10−3
- 2.5×10−3
- 5×10−4
Q.
The pH of 0.1M solution of cyanic acid (HCNO) is 2.34. Calculate the ionization constant of the acid and its degree of ionization in the solution.
Q. H3A is a weak triprotic acid (Ka1=10−5, Ka2=10−9, Ka3=10−13).
What is the value of pX of 0.1 M H3A(aq) solution?
Given pX=−logX and X=[A3−][HA2−].
What is the value of pX of 0.1 M H3A(aq) solution?
Given pX=−logX and X=[A3−][HA2−].
- 8
- 7
- 9
- 10
Q. Calculate [OH−] of 0.01 M ammonium hydroxide solution. The ionization constant for NH4OH is 1.8×10−5 M.
- 7.84×10−4M
- 1.56×10−5M
- 4.24×10−4M
- 0.88×10−5M
Q. One litre of solution contains 10−5 moles of H+ ions at 25∘C percentage ionisation of water in solution is:
- 1.8×10−7 %
- 1.8×10−9 %
- 3.6×10−9 %
- 1.8×10−11%
Q. A solution is saturated with SrCO3 and SrF2. The [CO2−3] is found to be 1.2×10−3M. if the value of solublity product of SrCO3 and SrF2 are 7.0×10−10 and 7.9×10−9 resectively.The concentration of F− in the solution would be
- 3.7×10−6M
- 3.2×10−3M
- 3.7×10−2M
- 5.1×10−7M
Q. What is the pH of a 1.0 M solution of acetic acid? To what volume of one litre of this solution be diluted so that the pH of resulting solution will be twice the original value? Given Ka=1.8 ×10−5, log10 4.2426×10−3=2.3724
- 2.78×104 litre
- 2.78×102 litre
- 3.68×105 litre
- 3.68×102 litre
Q.
An ionizing solvent has
Low value of dielectric constant
High value of dielectric constant
A dielectric constant equal to 1
Has a high melting point
Q. An aqueous solution contains 0.10 M H2S and 0.20 M HCl. If the equilibrium constants for the formation HS− from H2S is 1.0×10−7 and that of S2− from ions HS− is 1.2×10−13 then the concentration of S2− ions in aqueous solution is:
- 6×10−21
- 5×10−8
- 5×10−19
- 3×10−20
Q.
Rate = What is the effect on rate constant on increasing bromide ions?
Q. Which one is the correct order of acidity?
- CH2=CH2>CH3−CH=CH2>CH3−C≡CH>CH≡CH
- CH≡CH>CH3−C≡CH>CH2=CH2>CH3−CH3
- CH≡CH>CH2=CH2>CH3−C≡CH>CH3−CH3
- CH3−CH3>CH2=CH2>CH3−C≡CH>CH≡CH
Q. PCl5 dissociates as PCl5(g)⇌PCl3(g)+Cl2(g). If total pressure at equilibrium of the reaction mixture is P and degree of dissociation of PCl5 is x, the partial pressure of PCl3 will be:
- (x1+x)×P
- (x1+x)×P
- (2x1+x)×P
- x×P