A piezo-electric type pressure sensor has a sensitivity of 1 mV/kPa and a bandwidth of 300 Hz to 300 kHz. For a constant (dc) pressure of 100 kPa, the steady state output of the sensor in millivolt is
0

Open in App

Solution

The correct option is A 0
For constant (DC) pressure steady state output of piezoelectric crystal = 0 mV

Suggest Corrections

Similar questions

Q. A piezoelectric type 50 MPa full-scale pressure sensor with built-in electronics has a sensitivity of 100 mV per MPa. If this sensor is subjected to a static pressure of 10 MPa then its output will be

Q. A pressure sensor has the following specifications:

Sensitivity at the design temperature = 10 V/MPa.

Zero drift = 0.01 V/°C

Sensitivity drift = 0.01 (V/MPa)/°C

When the sensor is used in an ambient 20°C above the design temperature, the output from the device is 7.4 V. The true value of the pressure will be

Q. Two closed vessels of equal volume contain air at pressure

100 kPa

and temperature

250 K

and are connected through a narrow tube. If one of the vessels is now maintained at

250 K

and the other at

300 K

, what will be the pressure in the vessels?

Q. A C-type Bourdon tube is used to measure pressure in a pipe and it indicates a pressure of

10 k P a

. If atmospheric pressure is

101.3 k P a

. Then the absolute pressure in the pipe (in kPa) is

A gas is initially at a pressure of 100 kPa and its volume is $2.0 m^{3}$ . Its pressure is kept constant and the volume is changed from $2.0 m^{3} t o 2.5 m^{3}$ ,then Its volume is now kept constant and the pressure is increased from 100 kPa to 200 kPa. The gas is brought back to its initial state, the pressure varying linearly with its volume. (a) Whether the heat is supplied to or extracted from the gas in the complete cycle ? (b) How much heat was supplied or extracted ?

Join BYJU'S Learning Program

A piezo-electric type pressure sensor has a sensitivity of 1 mV/kPa and a bandwidth of 300 Hz to 300 kHz. For a constant (dc) pressure of 100 kPa, the steady state output of the sensor in millivolt is 0

The correct option is A 0For constant (DC) pressure steady state output of piezoelectric crystal = 0 mV

A piezo-electric type pressure sensor has a sensitivity of 1 mV/kPa and a bandwidth of 300 Hz to 300 kHz. For a constant (dc) pressure of 100 kPa, the steady state output of the sensor in millivolt is
0

The correct option is A 0
For constant (DC) pressure steady state output of piezoelectric crystal = 0 mV