CameraIcon

SearchIcon

MyQuestionIcon

3

You visited us 3 times! Enjoying our articles? Unlock Full Access!

Excess Pressure in Bubbles

Calculate the...

Question

Calculate the bite angle when rolling plates 12 mm thick using work rolls 600 mm diameter and reducing the thickness by 3mm

Open in App

Solution

$B i t e a n g l e : θ = t a n^{- 1} ⎛ ⎜ ⎜ ⎜ ⎝ \frac{\sqrt{R Δ h}}{R - \frac{Δ h}{2}} ⎞ ⎟ ⎟ ⎟ ⎠$

$H e r e, Δ h = 3 m m, R = 300 m m$

$θ = t a n^{- 1} (\frac{\sqrt{300 \times 3}}{300 - 1.5}) = {5.73}^{\circ}$

Suggest Corrections

thumbs-up

0

Similar questions

Q. In a single pass rolling process using 410 mm diameter steel rollers, a strip of width 140 mm and thickness 8 mm undergoes 10% reduction of thickness. The angle of bite in radians is

Q. In a rolling process, a sheet thickness is reduced by 10 mm using 800 mm diameter rolls. The roll strip contact length will be approximately

Q. In a rolling operation using rolls of diameter 500 mm if a 25 mm thick plate cannot be reduced to less than 20 mm in one pass, the coefficient of friction between the roll and the plate is

Q. The thickness of a sheet is reduced by rolling (without any change in width) using 600 mm diameter rolls. Neglect elastic deflection of the rolls and assume that the coefficient of friction at the roll-workpiece interface is 0.05. The sheet enters the rotating rolls unaided. If the initial sheet thickness is 2 mm, the minimum possible final thickness that can be produced by this process in a single pass is mm(round off to two decimal places).

Q. In a rolling process, thickness of a strip is reduced from 4 mm to 3 mm using 300 mm diameter rolls rotating at 100 rpm. The velocity of the strip (in m/sec) at the neutral point is

View More

Join BYJU'S Learning Program

similar_icon

Related Videos

lock

Surface Tension

PHYSICS

Watch in App

explore_more_icon

Explore more

Excess Pressure in Bubbles

Standard XII Physics

Join BYJU'S Learning Program

CrossIcon