Byju's Answer
Standard XII
Physics
Measuring Size
A:to minimize...
Question
A:to minimize the depression in a beam, it is designed as I shape girder R:The i shape girder have large load bearing surface,which decreases stess
Open in App
Solution
Suggest Corrections
1
Similar questions
Q.
A steel girder can bear a load of
20
t
o
n
s
. If the thickness of girder is double, then for the same depression it can bear a load of :
Q.
Consider the following statements
1. In a plate girder bearing stiffners are designed for bearing forces and they must also be checked for safety against compressive forces.
2. Secondary stresses are induced in a roof truss due to rigidity of joints.
Which of the above statements is (are) CORRECT?
Q.
Match List-I and List-II and select the correct answer using the codes given below the lists:
List-I
A. The shape of a cable suspended between two supports is defined by
B. The cable uniformly loaded along the horizontal span takes the shape of
C. The cable uniformly loaded along its length assumes the shape of
D. The girder in a suspension bridge transmits to its supports
List-II
1. A catenary
2. A little load
3. A parabola
4. Applied loads
Q.
A uniformly distributed load(w) of length shorter than the span crosses a girder. The bending moment at a section in girder will be maximum when
Q.
A simply supported I beam with its web horizontal is shown in the given figure. It is subjected to a vertical load
The shape of the shear stress distribution in the cross-section of the beam under the load would be
View More
Explore more
Measuring Size
Standard XII Physics
Solve
Textbooks
Question Papers
Install app