You visited us 1 times! Enjoying our articles? Unlock Full Access!

Byju's Answer

Other

Production

EDM - Mechanism of MRR - II

Deep hole dri...

Question

Deep hole drilling of small diameter, say 0.2 mm is done with EDM by selecting the total material as

Copper wire

No worries! We‘ve got your back. Try BYJU‘S free classes today!

Tungsten wire

Right on! Give the BNAT exam to get a 100% scholarship for BYJUS courses

Brass wire

No worries! We‘ve got your back. Try BYJU‘S free classes today!

Tungsten carbide

No worries! We‘ve got your back. Try BYJU‘S free classes today!

Open in App

Solution

The correct option is B Tungsten wire
Tungsten has a very high melting point therefore is more suitable.

Suggest Corrections

Similar questions

Q. Linked Data:
Blind hole

10 m m

diameter,

50 m m

deep are being drilled in steel block, drilling spindle speed is

600 r p m

, feed

0.2 m m / r e v,

point angle of drill is

120

Machining time (in

m i n

) per hole will be

Q. In a single pass drilling operation, a through hole of

15

mm diameter is to be drilled in a steel plate of

50

mm thickness. Drill spindle speed is

500

rpm, feed is

0.2

mm/rev and drill point angle is

118^{o}

. Assuming

2

mm clearance at approach and exit, the total drill time (in seconds) is

Linked Data:
Blind hole $10 m m$ diameter, $50 m m$ deep are being drilled in steel block, drilling spindle speed is $600 r p m$ , feed $0.2 m m / r e v,$ point angle of drill is $120$

During the above operation, the drill wears out after producing $200$ holes.Taylor's tool life equation is of the form $V T^{0.3} = C,$ where $V =$ cutting speed in $m / m i n$ and $T =$ tool life in min. Taylor's constnat $C$ will be

Q. A through hole is drilled in an aluminum alloy plate of 15 mm thickness with a drill bit of diameter 10 mm, at a feed of 0.25 mm/rev and spindle speed of 1200 rpm. If the specific energy required for cutting this material is 0.7

N - m / m m^{3}

, the power required is (round off to two decimal places).

Q. A hole of

20 m m

diameter is to be drilled in a steel block of

40 m m

thickness. The drilling is performed at rotational speed of

400 r p m

and feed rate of

0.1 m m / r e v

. The required approach and over run of the drill together is equal to the radius of the drill. The drilling time (in minute) is

Join BYJU'S Learning Program

Deep hole drilling of small diameter, say 0.2 mm is done with EDM by selecting the total material as

The correct option is B Tungsten wireTungsten has a very high melting point therefore is more suitable.

The correct option is B Tungsten wire
Tungsten has a very high melting point therefore is more suitable.